Make A Leather Notebook Cover With This DIY Guide

Here you will find instructions on how to make a leather notebook cover. You will learn how to make a leather notebook cover by following this do-it-yourself guide in this article. A perfect holiday gift, this may be ideal for your friends and family members. We’ll proceed to the next step without further ado. Find out more by reading on.

Things you need:

  • Small notebook
  • Leather needle
  • Nonstick pressure foot
  • Nylon upholstery thread
  • Double-sided tape
  • Glue
  • Steel ruler
  • Utility knife
  • Thin leather

Step 1: Cut the Required Pieces

For making the notebook cover, the leather piece has to be cut to two different sizes. Here are the pieces you need:

  • 2 pieces of pen tabs measuring 2″ x 1″
  • 1 piece of card piece measuring 4″ x 2.25″
  • 2 flap pieces measuring 6″ x 3″
  • 1 cover piece measuring 8.5″ x 6″

Step 2: Skive the Pen Tabs

The leather pieces are thinned so that they can be stacked one on top of the other. Using your skiver, peel off a thin layer of each pen tab. If you want to make the leather 50% thinner, you should aim for that.

Step 3: Attach the Card Pocket

The utility knife can be used to remove a small notch from the card pocket. If you want, you can round the corners using a corner edging tool. The bottom edge can be rounded using this tool to match your personal preference.

Step 4: Notch the Flaps

During this step, the flaps are cut out with notches. You only have to use your knife to cut a small notch measuring 1/4′′. This is then a good point to mark. The easiest way to do so is to use a hard object, such as a nail or pin. It is important to have each cut be straight during this process.

Step 5: Prepare the Cover for Stitching

You now need to apply some leather glue to the backs of each hand. It will take a few minutes for the glue to dry. The tabs may need to be flapped over for loops. In addition, you can use a clip right on the spot.

Once the flaps are placed on the outside of the cover, the notches should be placed on the inside of the flap. If you want at least one point to stop the flap, you might want to mark it.

Step 6: Assemble Everything

Lastly, everything had to be assembled. As soon as you have assembled everything, the book will be ready to use. If the cover is kept closed, you insert your pen into the strong loops. Making use of metal stamps is a great idea for extra details.

This article describes the five steps you need to follow to make a leather book cover. Going through the entire process with this will be much easier. In the hope that you will find this Do-it-yourself guide useful.

Leave a Comment